[Ffmpeg-devel] ASP/AVC defaults
Wed Dec 7 06:38:07 CET 2005
I am interested in spending some time updating the x264 interface to a
current level. However, along the way it has been noted that some of the
default values for some parameters are unsuitable not only for AVC, but for
ASP as well.
Default value alterations:
current = 12 (... in ffmpeg.c which overwrites 50 in utils.c)
proposed = 10 * framerate (for ASP and AVC)
current = 0
proposed = 2 for XviD and AVC, 1 for libavcodec MPEG-4
current = 0 (simple)
proposed = 2 (RD), or 0 with mbcmp set to SATD, except for turbo first pass
current = 0
proposed = 1 (this should probably be the default for MPEG-1/-2/-4)
current = disabled
proposed = enabled
current = 2
proposed = 2 for ASP, 10 for AVC
current = 31
proposed = 31 for ASP, 51 for AVC
I think this is disabled by default as the h.263 loopfilter is broken.
However, the x264 interface does not currently pass the value to the x264
library and so the default is taken which means it is enabled. This will
have to be dealt with in some way.
gop_size, max_b_frames and others may require different defaults for other
codecs such as MPEG-2. I'm not very familiar with libavcodec MPEG-4 and have
never used libavcodec MPEG-2 so other defaults may be necessary.
It should be apparent that there is the problem of different default value
requirements sharing the same parameters. I could add new parameters for
each codec as necessary (say -asp_qmin and so on) or I could design some new
method for handling defaults dependent on which codec is selected. I don't
know which way is better or if there are other, better methods that I
haven't thought of, but I would appreciate your input to select the most
acceptable method before I begin.
Rob(ert Swain, hereafter just Rob)
More information about the ffmpeg-devel