[FFmpeg-devel] [PATCH] Enable PAFF decoding
Fri Oct 12 19:21:21 CEST 2007
On Fri, 12 Oct 2007, Neil Brown wrote:
> On Wednesday October 10, lorenm at u.washington.edu wrote:
>> PAFF + spatial direct isn't implemented either.
> I tried to read up on "spatial direct" mode in the spec, and
> completely failed to understand it. Is there a "25 words or less"
> laymans version somewhere?
Spatial direct is a macroblock type in B-frames where no motion vectors
are coded. Instead, the mvs are derived as: median of neighboring
mvs, except in the case where the collocated block in the L1
reference frame is inter predicted with a mv of magnitude <= 1/4 pixel, in
which case the direct block uses mv=(0,0).
PAFF + temporal direct is probably broken too, since it still says
if(FRAME_MBAFF) around the mixed mode support. That code is probably ok
aside from the if, but you might have to modify the initialization of
map_col_to_list0_field in PAFF.
> Could this explain why the first couple of frames aren't being decoded
> correctly? How could I check?
If I- or P-frames are decoded incorrectly, then this isn't the cause.
Other than that, make a stream without direct macroblocks. But JM doesn't
have an option to turn off direct (only to select between spatial and
temporal), and x264 does have such an option but doesn't do PAFF, so good
More information about the ffmpeg-devel