[FFmpeg-devel] [PATCH 0/5] Support for Decklink output of EIA-708 and AFD

Marton Balint cus at passwd.hu
Sun Sep 9 23:59:36 EEST 2018



On Fri, 7 Sep 2018, Devin Heitmueller wrote:

> The following patches add support for output of 708 and AFD over
> the Decklink SDI interface.  This series is a subset of a series
> submitted in early January, with the hope of getting the less
> controversial parts merged upstream.
>
> Note compared to the previous series this includes a bit of
> refactoring to separate out the generation of AFD and CC lines from
> the actual output.  This makes the exception handling more
> straightforward as well as ensuring that one VANC type being
> invalid for some reason doesn't cause all the other types to
> not be output (in the previous series, the function would bail
> out if there was a problem with any VANC data, even if all the
> other VANC data was perfectly valid).
>
> Devin Heitmueller (5):
>  v210enc: Pass through A53 CC data
>  libavdevice/decklink: Add support for EIA-708 output over SDI
>  Allow AFD data to be embedded in AVPacket
>  v210enc: Pass through Active Format Description (AFD) data

Thanks, I applied patches 1-4.

>  decklink: Add support for output of Active Format Description (AFD)

Regarding this one, I noticed you always set the AFD in line 12. Are you 
sure that it is OK to use line 12 for all resolutions? Also, I think for 
interlaced formats you should set AFD for both fields, otherwise some 
equipment might scale/crop the two fields of a picture differently...

Regards,
Marton


More information about the ffmpeg-devel mailing list