[FFmpeg-user] Crash on DAR/SAR source change while HW transcoding

Dennis Mungai dmngaie at gmail.com
Wed Jun 6 18:25:22 EEST 2018


And with CUVID, in particular: It's decoders are very fragile.

You did mention that disabling hwaccel (cuvid?) raised your processor load
significantly, correct?

Can you confirm whether you're applying any filters down the encoder
pipeline?
Also, what processor are you using?

On 6 June 2018 at 16:14, Carl Eugen Hoyos <ceffmpeg at gmail.com> wrote:

> 2018-06-05 18:29 GMT+02:00, Mitja Pirih <mitja at alternet.si>:
> > On 05. 06. 2018 16:15, Carl Eugen Hoyos wrote:
> >> 2018-06-05 10:55 GMT+02:00, Mitja Pirih <mitja at alternet.si>:
> >>
> >>> I am transcoding a live channel from live source. Everything
> >>> works as expected until SAR/DAR changes then ffmpeg
> >>> crashes out.
> >>
> >> If you experience a crash with FFmpeg, please provide
> >> backtrace, disassembly and register dump.
> >
> > Carl Eugene, sorry I should have expressed myself better.
> > ffmpeg stopped, there was no kernel crash.
>
> Thank you for the confirmation.
>
> It is possible that the hardware encoders (as opposed to
> FFmpeg's implementation) do not support aspect change.
> You could partly test by using only hardware decoding
> and software encoding and by using software decoding
> and hardware encoding.
>
> Carl Eugen
> _______________________________________________
> ffmpeg-user mailing list
> ffmpeg-user at ffmpeg.org
> http://ffmpeg.org/mailman/listinfo/ffmpeg-user
>
> To unsubscribe, visit link above, or email
> ffmpeg-user-request at ffmpeg.org with subject "unsubscribe".
>


More information about the ffmpeg-user mailing list