[FFmpeg-user] Decklink timestamp_align, what should it do?
bouke at editb.nl
Sun May 2 12:50:42 EEST 2021
> On 2 May 2021, at 11:02, Marton Balint <cus at passwd.hu> wrote:
> On Sun, 2 May 2021, Bouke wrote:
>> From the manual:
>> Capture start time alignment in seconds. If set to nonzero, input frames are dropped till the system timestamp aligns with configured value
>> Ok, when I put -timestamp_align in my command, it does wait ‘a bit’ before starting capture.
>> That’s what I’m after, but i have no clue how long it waits. It’s not a ‘wait X seconds’ for sure.
> It waits until UTC modulo timestamp_align becomes 0. So for 60 it waits until a full minute boundary is reached.
Ok, but what is ' UTC modulo’ ?
If i enter 0, it starts capturing immediately, higher values do give ‘a’ delay, but it’s not predictable at all.
(It’s off by a random value, up to 30% difference from what I expect…)
> ffmpeg-user mailing list
> ffmpeg-user at ffmpeg.org
> To unsubscribe, visit link above, or email
> ffmpeg-user-request at ffmpeg.org with subject "unsubscribe".
More information about the ffmpeg-user